[quake2] To all the mouse problem peoples

[Anders Storsveen]

you have a little strange setup, you use evdev and "Dev Name", how do you  
get that name? and if you change to another mouse, does it still work?

On Sun, 20 Mar 2005 15:29:56 +0100, Anders Storsveen <wakko at generation.no>  
wrote:

> the grep gives no DGA, but If its that omit dga tingy i don't get  
> fullscreen correctly with it on, also it didn't help my mouseacc.
>
> my mouse is set up like this:
>
> Section "InputDevice"
>    Driver       "mouse"
>    Identifier   "Mouse"
>    Option       "ButtonNumber" "6"
>    Option       "Device" "/dev/input/mice"
>    Option       "Protocol" "ExplorerPS/2"
>    Option       "ZAxisMapping" "4 5"
>    Option       "NoAccel" "on"
> EndSection
>
>
> On Sun, 20 Mar 2005 15:20:54 +0100, Julien Langer <jlanger at zigweb.de>  
> wrote:
>
>> On So, 2005-03-20 at 04:11 +0100, Anders Storsveen wrote:
>>> common, I need to figure out what makes your mouse have no acc and my
>>> mouse have? what interface does it use, and how do you configure that
>>> interface?
>>>
>>
>> Have you tried it with enabled DGA?
>> Type "xdpyinfo | grep DGA" to check whether the DGA extension is loaded
>> or not.
>>
>>
>> That's my mouse configuration:
>> Section "InputDevice"
>>         Identifier  "Mouse0"
>>         Driver      "mouse"
>>         Option      "ZAxisMapping" "4 5"
>>         Option      "Buttons" "12"
>>         Option      "Protocol"  "evdev"
>>         Option      "Dev Name" "Logitech USB Receiver"
>>         Option      "Resolution" "800"
>> EndSection
>>
>> Besides this I haven't set up anything special I think..
>>
>
>
>



-- 
Anders Storsveen
The Next Generation
http://www.generation.no