[Gtkradiant] [Bug 1065] vertex editing moves more than just selected vertices

[bugzilla-daemon at zerowing.idsoftware.com]

http://zerowing.idsoftware.com/bugzilla/show_bug.cgi?id=1065





------- Additional Comments From jolynsbass at hotmail.com  2005-10-26 15:34 -------
Here's an example:
Open radiant create a 64x64x16 platform. create another of the same dimensions 
128 units away(on a horziontal line), now create a "bridge" connecting the 
two - 128x32x16. 

Raise 1 platform by 64 units vertically. Now select the "bridge", and choose 
edit vertices. Select all of the vertices at one end of the "bridge" which was 
by platform, and raise them to line up with the raised platform. It aligns 
perfectly.

(At this point you can rotate the entire ensemble by 45degrees and things will 
still be perfectly aligned vertically.)

Now, perform the entire operation again, but this time, before you raise the 
platform, rotate the whole thing by 45degrees. Then, raise the platform - no 
problems. Now, try to match up the vertices of one end of the "bridge" with 
the upper platform. You'll get close, but if you zoom in closely, you'll see 
that you are no longer aligned on the grid. No amount of adjusting will allow 
you to get there either, since, for every move of the selected end of the 
bridge, the other end moves, too. 

It seems like a bug to me. I can't see any reason why those vertices on the 
other end of the bridge should move, but they do, and the whole thing ends up 
mis-aligned off the grid.

Did that help?

-- 
Configure bugmail: http://zerowing.idsoftware.com/bugzilla/userprefs.cgi?tab=email
------- You are receiving this mail because: -------
You are the assignee for the bug, or are watching the assignee.