[Gtkradiant] GTKRadiant Bug Report

[Gordon 'djbob' Biggans]

Where GenSurf =3D prtview *cough*

-----Original Message-----
From: Timothee Besset [mailto:ttimo@idsoftware.com]=20
Sent: 31 May 2003 12:01
To: sohmikael@bluewin.ch
Cc: gtkradiant@zerowing.idsoftware.com
Subject: Re: [Gtkradiant] GTKRadiant Bug Report

.prt is a side effect of building a .bsp. It should also be writing out=20
a .bsp. If it does not, read carefully q3map2's output to identify the=20
problem.

.prt are portal files, and can be used by GenSurf to optmize the map's=20
portal placement

TTimo

81.62.86.239 wrote:

>This bug report was submitted from 81.62.86.239 using the Bug Report
Submission Form on the QERadiant Website at 05:53:23 CDT May 31, 2003.
>
>---
>
>BUG REPORT
>
>CPU/RAM/Operating System: 1.2ghz/768/xp
>Hard Drive Space: 50gb
>Video Card/OpenGL Drivers: geforce4 ti4600
>Version of GTKRadiant: 1.2.13
>
>Error:
>it always builds a .prt file after i run the BSP/fullvis
>
>Why does it makes a .prt file? and not a .bsp file?=20
>
>i made a map for sof2, i have there version 1.3.
>
>
>Cause of Error:
>i made a map and then it always make a prt file!
>
>User Email: sohmikael@bluewin.ch
>
>_______________________________________________
>Gtkradiant mailing list
>Gtkradiant@zerowing.idsoftware.com
>http://zerowing.idsoftware.com/mailman/listinfo/gtkradiant
>
>
> =20
>



_______________________________________________
Gtkradiant mailing list
Gtkradiant@zerowing.idsoftware.com
http://zerowing.idsoftware.com/mailman/listinfo/gtkradiant