[Gtkradiant] [Bug 611] clipper tools not "always" use caulk

[gtkradiant@zerowing.idsoftware.com]

http://zerowing.idsoftware.com/bugzilla/show_bug.cgi?id=611

ttimo@idsoftware.com changed:

           What    |Removed                     |Added
----------------------------------------------------------------------------
             Status|NEW                         |ASSIGNED



------- Additional Comments From ttimo@idsoftware.com  2002-09-19 16:30 -------
yeah it happens

- it's not due to bad brushes / duplicate planes (the brush sample goes through
BSP just fine)

- it's not due to brush faces on Z=0

If you retexture the whole brush set into something though, it no longer
happens. The cut uses caulk everywhere just fine.

multiple selection or the fact that it's a func group doesn't seem to matter

wonder if we have special cases for the caulking such as particular texture
being used elsewhere on the brush disabling it? this may be triggering?