[ut3] Linux Server and AMD Athlon 2600 dual processor

[Arne Brodowski]

Hi Rick,

to quote Ryan from the 14th October:

---
It's built with -march=pentium4 -mtune=pentium4 -msse2 -mfpmath=sse ... 
so it will use generic instructions that were only available on P4-level 
hardware, and sse2 for all math operations.

If you're still on Pentium III level hardware, it's time to upgrade.
---

AMD Athlon 2600MP CPUs don't have the SSE2 Instruction-Set, so you can't 
run the UT3 binary.

best regards,
Arne


Rick Page wrote:
> Hello everyone,
> I have been running the demo for some time on a 2.1GHz Celeron without
> too much problems. I am now trying to get it to run on an AMD Athlon
> 2600 MP. I am not sure if it is a problem with the betademo or if it
> is a problem with my setup. The Celeron is running Red Hat 9 and the
> AMD is running CentOS 5. Yes I know that there really isn't much a
> difference between the two OS's. When I try running ./ut3demo server
> DM-ShangriLa?........., I get an Illegal instruction. Nothing else
> comes up, just Illegal instruction. If I just try ./ut3demo, I get the
> same message. Yes, I know, not very helpful is it. That is why I am
> leaning a little more towards my setup, but just wanted to check to
> see if anyone else had this problem. Any helpful suggestions on where
> to start to look would be greatly appreciated.
> Rick
> 
> ---
> To unsubscribe, send a blank email to ut3-unsubscribe at icculus.org
> Mailing list archives: http://icculus.org/cgi-bin/ezmlm/ezmlm-cgi?64
> 
>