[cod] Apparently I'm missing some config files

[James Kreuziger]

Ok, I'm going to be anal here.  Everything looks good, EXCEPT one word.
It's NOT neways, it's anyways.

Don't know why that is bugging me so much, but I had to get that out of my
system.

-Jim

----- Original Message -----
From: "Nathan Peters" <natedog550 at hotmail.com>
To: <cod at icculus.org>
Sent: Tuesday, November 25, 2003 8:44 AM
Subject: Re: [cod] Apparently I'm missing some config files


> It's easier to copy off the CD.  The files are uncompressed on the CD
> neways.  You can find the files you're looking for on the CD.  I copied
from
> the CD and only problems I had starting was because of internal network
and
> router settings etc.  I'd recommend pulling files off of the CD instead of
> an installed windows directory.  Besides, if you're network is havin' any
> kind of errors or port collisions etc you could be getting corrupt files
> copyin' over and wouldn't even know it until you start trying to run the
> server.  And always do and MD5 check on the pk3 files too and compare to
the
> install instructions.  Should be at the bottom.  That insures integrity of
> the pk3 files.  Neways, hope u get it goin'.
>
> Nathan
>
> ----- Original Message -----
> From: "Sam Evans" <sam at neuroflux.com>
> To: <cod at icculus.org>
> Sent: Tuesday, November 25, 2003 10:27 AM
> Subject: Re: [cod] Apparently I'm missing some config files
>
>
> > Hmm..  Well, I made sure they are in main (lowercase) and the .so is in
> > there as well, but I'm missing the localization.txt file -- according to
> > the README.
> >
> >
> >
> > On Tue, 25 Nov 2003, Steven Hartland wrote:
> >
> > > It is all u need if your getting a missing config file error
> > > the pk3 files are either corrupt / missing or in the wrong place.
> > >
> > >     Steve / K
> > > ----- Original Message -----
> > > From: "Sam Evans" <sam at neuroflux.com>
> > > To: <cod at icculus.org>
> > > Sent: 25 November 2003 16:02
> > > Subject: [cod] Apparently I'm missing some config files
> > >
> > >
> > > > Thinking that all I would have to do is upload the .pk3 files from
my
> > > > Windows installation, that's all I have done.  But it looks like I'm
> > > > missing some other .cfg files?
> > > >
> > > > Could anyone be so kind as to forward them on to me?
> > > >
> > > > Thanks,
> > > > Sam
> > > >
> > > >
> > >
> >